Filter
Top Products
DCP Operation
3-533910-A2-GN32-30 November 1996
BlksErrd=xxxxxxx displays the number of blocks of data found in error (block size is 1000 bits
per block). BlksRcvd=xxxxxxx
displays the total number of blocks of data received. The message
NoSync appears as a value for BlksErrd while the modem’s receiver is synchronizing. The
message
OvrFlw appears as the value for BlksErrd if the counter overflows.
Press the
key to display
BlksRcvd=xxxxxxx, number of blocks of data received.
The Pattern test can be exited and reentered without restarting the test. The BlksErrd and BlksRcvd
continue counting.
If the Test Timeout configuration option is enabled, T
est T
imeout
appears at the conclusion of the
test. If it is disabled, the test operates until aborted. For more information on the Test Timeout
configuration option, refer to the Test
section in Chapter 4.
To exit this function and remain in the T
est branch, press the
key
. To exit and return to the
Top-Level menu, press the
key
.
Sub-Network Health and Status Branch
The Sub-Network Health and Status (SubHS) function is not available on multipoint
tributary modems or with certain modulations (V.29, V.33, V.22bis, and V.27bis).
The SubHS branch of the Top-Level menu allows you to display alarm conditions in downstream
modems.
“Status”
SubHS
Status Configure Plist Control
Test
Call_Setup Tlk/Data Security Remote
To access the SubHS branch from the Top-Level menu, make the following selections:
F1
Leased:19.2
Test SubHS
F2
F3
Press the
key until SubHS appears. Select SubHS.
NOTE
If there are no modems in the multipoint poll list, the message Poll
List Empty! appears on the second line of the LCD.