Filter
Top Products
DCP Operation
3-473910-A2-GN32-30 November 1996
To access Abort from the Test branch, make the following selection:
F1
Test: >
Abort Self
F2
F3
Select Abort.
F1
Test:Abort
Command Complete
F2
F3
The
modem stops all tests currently in progress and displays the
Command Complete
status
message on the LCD.
To exit this function and remain in the T
est branch, press the
key
. To exit and return to the
Top-Level menu, press the
key
.
Self
Self performs an internal self-test of the modem, which takes less than a minute to complete. The
modem must be offline; otherwise, Invalid Command
appears.
WARNING
When this test is run in Remote mode, it will cause the Remote
mode session to be lost. The Remote mode session can be
reestablished after the self-test is complete (usually one or two
minutes). If the remote self-test fails, there will be a Device
Failure alarm message when the remote modem’s Device
Health and Status (DeviceHS) branch is accessed.
To access Self from the Test branch, make the following selection:
F1
Test: >
Abort Self
F2
F3
Select Self. (All LCD cells and DCP status indicators light.)