Filter
Top Products
DCP Operation
3-333910-A2-GN32-30 November 1996
To exit this function and remain in the Control branch, press the
key
. To exit and return to the
Top-Level menu, press the
key
.
EIA LEDs
Use the EIA LEDs function to change the port that controls the front panel LEDs. This function
allows the front panel EIA LEDs to display the activity of a selected digital interface.
To access EIA LEDs from the Control branch, make the following selections:
F1
Control:
EIA_LEDs
F2
F3
Press the
key until EIA_LEDs appears. Select EIA_LEDs.
F1
EIA_LED : xxxxx
Port1 CC
F2
F3
Press the F1 key until the appropriate digital interface appears.
The xxxxx field displays the currently selected interface. The valid interfaces are Port1, and
depending on the configuration option, either CC (NMS Control Channel), or DC (Diagnostic
Channel). Refer to the section
Miscellaneous Configuration Options, Diag Connection
in Chapter 4.
Select the appropriate interface by pressing the corresponding function key.
F1
EIA_LED : xxxxx
Command Complete
F2
F3
After
selecting the desired interface, the message
Command Complete appears on the bottom line
of the LCD and the selected interface appears in the xxxxx field.
To exit this function and remain in the Control branch, press the
key
. To exit and return to the
Top-Level menu, press the
key
.
NOTE
The Port1 interface is the only display allowed on the 3911 modem,
therefore, the entire EIA LEDs branch is masked.