Filter
Top Products
DCP Operation
3-133910-A2-GN32-30 November 1996
Messages listed in T
able 3-5 are dial access security messages.
Table 3-5
Dial Access Security Messages
Dial Access Security
Message
Indicates
Get VF PsWd The answering modem is waiting for the originating caller to transmit a VF
password.
Get DTE PsWd The answering modem is waiting to receive a valid DTE password from the
remote DTE.
VF PsWd Timeout The modem did not finish answering a call (disconnected) because the allowed
time limit was exceeded before the modem received a VF password from the
originating dialer.
Unknown DTEpswd The modem did not finish answering a call (disconnected) because the DTE
passwords received from the remote DTE were invalid.
No Orig PsWd The modem did not attempt to establish a call as requested because the AT dial
command did not contain an originate access password.
Unknown VF PsWd The modem did not finish answering a call (disconnected) because the modem
received an invalid VF password.
DTEpswd Timeout The modem did not finish answering a call (disconnected) because the allowed
time limit was exceeded before the modem received a DTE password from the
remote DTE.
Inval Orig PsWd The modem did not attempt to establish the call as requested because the
originate password in the AT dial command was not valid.
DTR Dial Blockd DTR dialing is not permitted when security is enabled. This message appears if
DTR dialing is used and Answer Access or Originate Access security is
enabled.
SecurityBlocked The access verification capabilities are not available and the modem does not
pass data to the DTE under any circumstances. This message appears only
when the modem is in base mode (a mode that occurs during a firmware
download) and Answer Access Security is enabled.
The Top-Level menu’s main branches appear on the LCD in the order of Status, Configure,
Control, T
est, Call Setup, T
alk/Data, Security
, and Remote. These branches are discussed in this
chapter except for the Configure branch which is reserved for Chapter 4,
DCP Configuration, and
the Security branch which is reserved for Chapter 6,
Dial Access Security
.