DCP Operation
3-593910-A2-GN32-30 November 1996
F1
Dial Standby
Command Complete
F2
F3
If the modem is operating in a Dial Backup mode, the Dial Standby function forces the modem to
primary leased lines and the LCD displays the status message
Command Complete.
Once the modem is in Dial Standby mode, Return_to_Dial appears on the LCD. Selecting this
function forces the modem to the backup network and the LCD displays the status message
Command Complete.
Change Directory
Change Directory allows you to enter or modify telephone numbers. The modem has nonvolatile
memory locations that allow you to store up to 24 telephone numbers. Each directory location can
accept up to 40 characters; this includes the telephone number and dial command modifiers. Any
telephone number dialed using the DCP Dial command must appear in a directory location.
NOTE
If the modem is operating on leased lines and has a dial line
attached for dial backup purposes, it is required that directory
location 1 contain the telephone number used for dial backup.
To
access Change Directory from the Call Setup branch, make the following selections:
F1
Call Setup: <
Change_Directory
F2
F3
Press the
key until Change_Directory appears. Press any function key to select
Change_Directory.
F1
01:551234z
Nxt " #
F2
F3
The phone number listed in directory location 1 appears. Select Nxt to display other directory
locations.