Filter
Top Products
DCP Operation
3-113910-A2-GN32-30 November 1996
Table 3-3
(3 of 4)
Top-Level Menu Status
Status IndicatesMessage
Call Failure
Cont.
No Dial–DTR The modem cannot dial because DTR is OFF.
No Dial–Test The modem cannot dial because it is running a Test.
No Dial Tone The modem has aborted the call because it cannot detect a dial
tone.
No Quiet
Answer
The modem has detected No Quiet Answer (@) before the time-out
setting of the No Answer Disconnect configuration option.
Ringback
Timeout
The answering modem did not answer within the time limit specified
by the No Answer Timeout configuration option. A ringback signal
was detected.
Trunk Busy The modem is receiving a fast (trunk) busy.
Wrong Call The call was answered, but not by a modem. No answer tone.
Call Disconnect ATH Disconnect The modem has disconnected due to an ATH command.
Bad Lines Disc The modem has disconnected because the lines do not support the
modulation and/or data rate selected.
No Carrier Disc The modem disconnects due to the loss of carrier signal from the
remote modem.
DTR
Disconnect
The modem has disconnected due to the loss of DTR from the DTE.
EC Disconnect The modem has disconnected due to failure to negotiate Error
Control mode.
Inv Rate Disc When using V.32bis modulation, the remote modem does not
support the data rate used by the local modem.
LnCurrnt Disc The modem has disconnected due to the loss of line current.
LongSpace
Disc
The modem has disconnected due to the detection of a long space.
NoData Disc The modem has disconnected due to a lack of transmitted and
received data.
Disconnecting The modem has begun the disconnect sequence.
RmtCmnded
Disc
The modem has disconnected due to a V.32 Cleardown received
from the remote modem.
Talk Mode The modem is in Talk mode.
Firmware
Download
Result
DownldOnly
Mode
A local download of firmware or a remote cloning of firmware has
failed. The modem is currently in a Download Only mode in which
only another download attempt is possible.
Frmware
Upgrade
A local download of firmware or a remote cloning of firmware was
successful.
RemClone
Failed
A remote cloning of firmware has failed. This message appears on
the local modem’s LCD.