Filter
Top Products
COMSPHERE 3900 Series Modems
3-64 November 1996 3910-A2-GN32-30
Manual Dialing When the Remote Modem is Configured for Manual Answer
NOTE
On both modems, the Line Current Disconnect configuration option
(refer to the
Line Dialer
section in Chapter 4) must be set to Disable.
This configuration option does not appear on Models 3910-A1-401
and 3911-B1-001.
If you are originating a call using a telephone and the remote modem is configured for Manual
Answer, perform the following procedure.
Once the remote telephone is answered by the remote user, you must both decide when to place the
modems into Data mode. Y
ou must both select Tlk/Data at approximately the same time and hang
up the handset to begin the handshaking sequence.
If the handshake is successful, the modems are in Data mode and
OnLine
appears on the LCD.
NOTE
If the remote modem is not a 3900 Series modem, then the remote
user must consult that modem’s operator’s manual to perform a
similar operation.
Once
the modems are online, the status messages listed in T
able 3-3 appear on the Top-Level
display.
It is not necessary to specify an originating or answering modem when dialing via the DCP
because the answering modem detects that it is receiving a ringing voltage and automatically
defaults to Answer mode.
Security Branch
The Security branch allows you to create, edit, and save parameters that determine how the
modem’s security is executed. For security procedures and configuration options, refer to
Chapter 6,
Dial Access Security
.