Filter
Top Products
COMSPHERE 3900 Series Modems
5-24 November 1996 3910-A2-GN32-30
Table 5-4
(10 of 13)
391x Series S-Registers
S-Register
DCP LCD
Command
Sequence
Description
S82 V.32bis Autorate (Leased Line). Register determines if Autorating is
used on leased lines when connected in V.32bis mode.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
Configure\Edit\
Leased Line
S84 AT Command Mode. Register determines how the modem responds to
valid and invalid AT commands.
Register has the following values:
0 = Normal
1 = No ERROR
2 = No Strap or ERROR
The factory setting is Normal.
Configure\Edit\
DTE Dialer
S85 Fast Disconnect. Register allows the modem to disconnect
immediately after receiving a disconnect command from a local DTE
or its own diagnostic control panel.
Register has the following values:
0 = Disable
1 = Enable
The factory setting is Disable.
Configure\Edit\
Line Dialer
S88 Straps When Disconnected. Register determines whether or not
configuration options in the Active (Saved) configuration area are
reloaded to Active (Operating) when a disconnect occurs.
Register has the following values:
0 or 231 = No Change
1 or 232 = Reload
The factory setting is No Change.
Configure\Edit\
Misc