Filter
Top Products
16 Pelco Manual C690M-E (11/04)
9. Connect a PC.
• If a PC will be connected directly to the DVR, connect it at the Ethernet port on the
rear of the DVR using a T568A/B cross-over shielded CAT5 cable with shielded RJ-45
connectors (not supplied). The maximum length is 328 feet (100 m).
Refer to the charts below:
RJ-45 Color Chart
Wire 1 White with an orange stripe
Wire 2 Orange
Wire 3 White with a green stripe
Wire 4 Blue
Wire 5 White with a blue stripe
Wire 6 Green
Wire 7 White with a brown stripe
Wire 8 Brown
Straight-Through Cable Crossed Cable
Wire Becomes Wire Becomes
11 13
22 26
33 31
66 62
Figure 5. RJ-45 Color and Straight/Crossed Cable Pin-Outs Charts
• If the PC will be communicating with the DVR through an external modem rather than
over a network, connect a Pelco DX7000EM External Modem to the DVR’s COM 1
port. Connect the modem to a phone jack. This will let you dial up the DVR to
configure the unit or view live and recorded video. Response will be a little slower
than over a network.
• If connecting to a network, go to step 11.
10. Configure the PC. Refer to the
Configuring Your PC
section.