Filter
Top Products
Pelco Manual C690M-E (11/04) 17
11. a. Change the default network settings if necessary. Do the following:
• Connect the PC. Connect it at the Ethernet port on the rear of the DVR using a
T568A/B cross-over shielded CAT5 cable with shielded RJ-45 connectors (not
supplied).
• Refer to the
Changing the Default IP Address
section.
• Remove the PC.
b. Connect to an Ethernet network (LAN/WAN).
IMPORTANT:
If you are connecting to a network, the network administrator must deter-
mine if the DX2000’s default network settings (the default IP address 192.168.2.108:8004
and subnet mask 255.255.255.0) must be changed to avoid conflicts with another device on
the network. If they must be changed, DO NOT connect the DX2000 to the network until the
settings are changed.
If dedicating a PC exclusively to the DX2000, refer to the
Configuring Your PC
and
Changing
the Default IP Address
sections. If the network already has a PC, refer to the
Changing the
Default IP Address
section.
Once the DX2000’s network settings are correct, connect the DVR to a network hub
through the DVR’s Ethernet port using shielded CAT5 straight cable with shielded RJ-45
connectors (not supplied). The maximum length is 328 feet (100 meters). (Refer to Figure 5
for wire color and pin-out information.)
12. Configure the DX2000. The minimum requirements are that you must set the date and
time and either configure or disable the data ports. Do the following:
a. Turn on the DX2000 and the other equipment.
b. Access the DVR. Refer to the
Login
section.
c. If you are going to load a pre-saved configuration into the DX2000, do the following. If
not, skip to the next step.
Click Configuration, and then select File Utilities. In the Configuration Upload area,
select Browse. Locate the configuration file and select Open. Select Upload. The
configuration file uploads and the DX2000 automatically reboots, which may take
several minutes.
d. If you are connecting ATMs or POS devices, you must configure the data ports. Leave
unused ports disabled (the default).
•To configure: refer to the
Data Port Configuration
section.
•To disable: Click Configuration and then click General Information. Under the
Data Interface heading, click Disable Data and then click Save. Then click Ok.