Filter
Top Products
Pelco Manual C690M-E (11/04) 27
CHANGING THE DEFAULT IP ADDRESS
To change the default IP address, do the following:
1. The network administrator must assign a new IP address and subnet mask.
2. Turn on the DVR. Turn on the PC.
3. Open Internet Explorer on your PC. Type the DVR’s default IP address
(192.168.2.108:8004) in the Address box and press Enter. This lets the PC access the
DVR.
4. In the Enter Network Password dialog box that appears, enter the default administrative ID
(admin) and password (PELCOADM). (Only the password is case sensitive.) Click Ok.
The DVR displays the DVR Series screen.
5. Click the Configuration button.
6. On the menu that appears, click General Information.
7. In Network Settings, enter the new IP address. Change any other settings that require
changing, such as the subnet mask and gateway. (Note that your PC must be configured
with an IP address within the same IP subnet as the DVR. Contact your network adminis-
trator for help, if needed.)
8. Click the Save button. On the dialog window that appears, click Ok. The program auto-
matically reboots, after which your IP address is now changed (along with other settings
you changed).
9. Wait until the DX2000 reboots, and then enter the new IP address to access the unit.