Filter
Top Products
70 C1534M (1/06)
SOFTWARE INSTALLATION AND REGISTRATION
Please call Pelco’s 24-hour Technical Support at 1-800-289-9100 or 1-559-292-1981 before installing an upgrade or reinstalling the VMX200
software from CD.
VMX210 SOFTWARE REINSTALL
The following instructions are necessary only in the event that you need to reinstall the software. Do not complete these instructions unless
advised to do so by a Pelco Technical Support representative.
1. Uninstall the previously installed VMX200 software.
a. Click the Windows Start button.
b. Choose Settings > Control Panel.
c. Select Add/Remove Programs.
d. Select the VMX200.
e. Click Add/Remove or Change/Remove (Windows 2000).
NOTE: When you reinstall the VMX200 software, the existing database from the previous installation will be recognized and used for the new
installation. You should not change the installation directory when reinstalling the VMX200 software, otherwise the existing database will not be
found.
2. When the uninstall process is complete, close all programs on the VMX210 workstation.
3. Insert the VMX210 Resource CD into the CD drive on your VMX210 workstation.
4. The VMX200 Installation and User Guide window appears.
If it does not appear:
a. Select the Windows Start button.
b. Select Run.
c. Type D:\setup.exe (if necessary, substitute the appropriate letter of your CD drive for D).
5. Select Install VMX200.
6. Follow the on-screen instructions to complete the installation.
7. When the installation is complete you will be prompted to enter the Base License; see License ID below.
NOTE: When you reinstall the VMX200 software, the existing database from the previous installation will be recognized and used for the new
installation. You should not change the installation directory when reinstalling the VMX200 software, otherwise the existing database would not
be found.