Filter
Top Products
Chapter 4 LinePrinter Plus Emulation (with PCL-II)
218
Reset Cmd CFG Ld
When the printer receives a host data stream reset command
(ESC @ or ESC[K) in addition to resetting printer variables, the
selected configuration is loaded.
• Disable (default). The active emulation parameters are loaded
when the reset command is executed.
• Power-Up Config. The power-up configuration is loaded when
the reset command is executed.
• Current Config. The currently selected configuration is loaded
when the reset command is executed.
• Factory Config. The factory installed configuration is loaded
when the reset command is executed.
Set Substitution
When this option is activated, the character set overlay in RAM is
activated. This can also be accomplished through a host command
of SFCC RX. In either case, a flag is set indicating that the
substitution table is active. If the power-up configuration has Ld Set
at Pwrup and Set Substitution both enabled, the character set
overlay is automatically activated at power-up or during a soft reset.
See the
LinePrinter Plus Programmer's Reference Manual
for more
information.
Barcode X-Offset
• Disable (default)
• Enable. Allows text to print next to a barcode when xxxx and
yyyy are not set to the origin.