Filter
Top Products
Chapter 3 The Control Panel
30
microstep feature. Pressing VIEW/EJECT a second time
moves the paper back to the adjusted print position.
Eject Function — for pedestal models, when the VIEW/EJECT key
is pressed, the bottom of the last printed form will move to the tear
bar position. The message "READY TO TEAR/EJECT To Return"
displays. While in this position, pressing the UP or DOWN arrow
keys moves the paper up or down in 1/72 inch increments. Refer to
the Up and Down key functions for additional details on the
microstep feature. When the VIEW/EJECT key is pressed a second
time, the printer will move the paper to enable printing on the next
available form.
CANCEL
In offline mode, this key cancels all data in the print buffer, if
enabled in “ADVANCED USER” on page 281. The print buffer is
cleared without printing any of the data and the current paper
position is set as the top-of-form. If this function is disabled, the
CANCEL key will be ignored.
NOTE: Use of this key will cause loss of data
.
SET TOF
Sets the top-of-form on the printer. This key is active only when the
printer is offline and will not operate if the printer is in a fault
condition. The paper moves down to the print position and aligns to
the top-of-form. Refer to the
Quick Setup Guide
for complete
instructions on how to set the top-of-form.
NOTE: If there is any data in the buffer, the paper will move to the
last print position.
PRT CONFIG
In offline mode, PRT CONFIG prints the current short configuration.
This key requires a confirmation with the ENTER key; pressing any
other key will exit from this function. See “The Configuration
Menus” on page 53 for an explanation of configuration menus.