Filter
Top Products
Fault Messages
325
CLEARING
PROGRAM FROM
FLASH
No Status message:
emulation software
successfully
loaded into printer
RAM and the
checksum
matched. The old
program is now
being deleted from
flash memory.
No action is required.
CLOSE PLATEN Yes The platen lever is
open.
Close the platen lever.
COIL HOT No One or more
hammer coils are
overheating.
Contact your authorized
service representative.
1
CTL VOLT FAIL* No Controller voltage
failure.
Contact your authorized
service representative.
1
DIAGNOSTIC
PASSED
No Status message:
the printer passed
its memory and
hardware
initialization tests.
No action is required.
DO NOT POWER
OFF
No This is a standard
warning message
that displays while
the printer is
downloading
software.
Do not power off the
printer until downloading
is complete.
DRVR CIR BAD* No Hammer coil count
test failed.
Contact your authorized
service representative.
1
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution