Filter
Top Products
Chapter 7 Diagnosing Problems
342
STACKER FAULT Yes Stacker is not
functioning
correctly.
Check for obstructions in
the stacker area. If fault
persists, contact your
authorized service
representative.
1
STACKER FULL Yes Power stacker is
full of paper.
Remove paper.
STACKER JAM Yes This message is
triggered if there is
paper inside the
throat of the
stacker elevator,
but the elevator is
not moving.
1. Open the cabinet rear
door and check for
obstructions preventing
elevator movement.
Remove any
obstructions.
2. Run the print job again.
If the message appears
again, contact your
authorized service
representative.
1
TABLE MISMATCH
DOWNLOAD AGAIN
No Indicates that the
software update
has failed and
should be
reloaded.
Contact your authorized
service representative.
1
TCB CORRUPTED* No Fatal firmware
error on controller
board.
Contact your authorized
service representative.
1
TCP PORT BUSY Yes Error message
reported by the
Printer Manager
when ethernet
interface option is
installed.
Refer to the
Printronix
P7000 PSA3 Printers
Maintenance Manual
.
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution