Filter
Top Products
Fault Messages
337
PLEASE WAIT...
RESET IN
PROGRESS
N/A The printer finished
loading the
program into flash
memory and is
automatically
resetting itself.
No action is required.
POWER SAVER
MODE
N/A Status message:
printer is in low-
energy idle state,
all fans and higher
voltages are off,
only +5Vdc logic
circuits are active.
No action is required.
POWER SUPPLY
HOT
Yes Power supply
sensors report high
temperatures.
Check printer
environment. If hot or
dusty, relocate printer.
Contact your authorized
service representative if
this occurs frequently.
1
PRINTER HOT Yes Controller board
sensors report high
temperatures on
the board.
Check printer
environment. If hot or
dusty, relocate printer.
Contact your authorized
service representative if
this occurs frequently.
1
PRINTER UNDER
REMOTE
CONTROL
Yes Another user is
accessing the
printer remotely
with the remote
management
software utility.
Wait until the remote user
has finished their remote
management session, or
press any key to disable
the Printer Manger and
gain control of the printer.
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution