Filter
Top Products
B – Command Reference
Commands
B-24 SN0054628-00 A
Q
Keywords show port [port number]
An integer 1-8 for SANbox 8200-08 SSP/SANbox 8202-08 SSP or 1-16 for
SANbox 8202-16 SSP to indicate the Fibre Channel port.
show port *
* indicates all Fibre Channel ports on the SANbox SSP.
Examples Here is the output for port 1 on a demonstration system after running show
port 1.
Port1:
WWNN: 50:09:06:68:00:05:24:71
WWPN: 50:09:06:60:00:05:24:71
State: LINK_ESTABLISHED
Capability: ['FCP_INITIATOR', 'FCP_TARGET']
Type - Configured: AUTO Actual: N_PORT
Speed - Configured: NEGOTIATE Actual: 1G
Class - Capabilities: ['THREE']
Max Frame Size (in bytes): 2048
See Also "Disable Port Command" on page B-9
"Enable Port Command" on page B-11
"Modify Port Command" on page B-14
"Modify Ports Command" on page B-15
"Reset Port Command" on page B-17
"Show Ports Command" on page B-24
Show Ports Command
Returns diagnostic and status information for all the ports on the SANbox SSP
(8 ports for SANbox 8200-08/SANbox 8202-08 and 16 ports for
SANbox 8202-16). See the sample output in the Examples section, below, for
more information.
Syntax show ports
Keywords show ports
Indicates all Fibre Channel ports on the SANbox SSP.
Examples Here is the output for port 5 on a demonstration system after running show
ports.
Port5:
WWNN: 50:09:06:68:00:05:24:71
WWPN: 50:09:06:60:00:05:24:75
State: LINK_ESTABLISHED
Capability: ['FCP_INITIATOR', 'FCP_TARGET']
Type - Configured: AUTO Actual: N_PORT