Filter
Top Products
5 – Maintaining the SANbox SSP
Maintenance Mode
SN0054628-00 A 5-3
Q
3. Use the arrow keys to select a boot set, and then press the Enter key to boot
using the selection.
The selected boot set becomes the default boot set when the system is next
restarted.
NOTE: Boot set items marked DIAG are for use by QLogic field service
personnel; they should not be selected under normal operating
conditions.
5.3
Maintenance Mode
Maintenance Mode provides menu options for installing and upgrading your
SANbox SSP software. Maintenance Mode is accessible even when no valid boot
set is installed on the system.
To access Maintenance Mode from the local console:
1. Connect to the local administrative console using a terminal emulator, such as
HyperTerm.
2. Start or reboot the system. At the boot menu, use the arrow keys to select an
entry labeled Maintenance Mode, and then press the Enter key to boot using
the selection.
If the entry tagged with ip=dhcp is selected, the system attempts to obtain an
IP address automatically from a DHCP server. Otherwise, you must manually
configure IP from Maintenance Mode to enable access to the SANbox SSP
management port (labeled on the port side of the SANbox SSP).
3. Log into the system as kadmin.
The Maintenance Mode menu displays. The options are:
e: Reconfigure Ethernet
g: Get image package from network
i: Install image package
d: Delete image file
l: List available images to install
s: Show installed versions
r: Reboot
m: Show Menu