Filter
Top Products
B – Command Reference
Commands
B-10 SN0054628-00 A
Q
See Also "Enable Port Command" on page B-11
"Modify Port Command" on page B-14
"Modify Ports Command" on page B-15
"Show Port Command" on page B-23
"Show Ports Command" on page B-24
Disable snmpv3 Command
This command does not turn off Simple Management Protocol. By default, the
system runs Simple Network Management Protocol, version 2. Disabling SNMPv3
means that SNMPv2 is running instead of SNMPv3.
Syntax disable snmpv3
See Also "Enable snmpv3 Command" on page B-11
"Show snmpv3 Command" on page B-26
Disable User Command
Temporarily disables the user account without deleting it. The account can later be
enabled using the Enable User Command command.
Notes Only users belonging to the Administrator group can add, delete, and
disable/enable users, and the current user cannot be disabled or deleted.
Syntax disable user [user name]
Keywords disable user [user name]
Name of the user account that you are disabling.
See Also "Enable User Command" on page B-11
"Modify User Command" on page B-16
"Show User Command" on page B-27
"Show Users Command" on page B-27
Enable Eth Command
SANbox SSP includes three Ethernet connections, MGMT, HA1, and HA2. This
command enables the specified Ethernet connection so that it can send or receive
network traffic.
Syntax enable eth [ethernet name]
Keywords enable eth [ethernet name]
Name of the Ethernet that you are enabling: MGMT, HA1, or HA2.