Filter
Top Products
B – Command Reference
Commands
SN0054628-00 A B-17
Q
See Also "Disable User Command" on page B-10
"Enable User Command" on page B-11
"Modify User Command" on page B-16
"Show User Command" on page B-27
"Show Users Command" on page B-27
Quit Command
Exits this command line interface session, terminates the telnet session, and logs
the user out.
Syntax quit
See Also "Exit Command" on page B-12
Reboot Command
Restarts the SANbox SSP.
Syntax reboot
Reset Port Command
Shuts down the port and then restarts it, leaving the properties of the port
unchanged. Use this command to clear a port that is in an unknown state and
trigger the discovery process.
WARNING!!
Running this command disrupts any traffic on this port, and should
never be performed on a port that is moving data. Doing so could
cause read/write failure and error conditions in software if traffic has
occurred.
Syntax reset port
[port number]
*
Keywords reset port [port number]
An integer 1-8 for SANbox 8200-08 SSP/SANbox 8202-08 SSP or 1-16 for
SANbox 8202-16 SSP to indicate the Fibre Channel port.
reset port *
* indicates all Fibre Channel ports.
See Also "Modify Ports Command" on page B-15
"Show Port Command" on page B-23
"Show Ports Command" on page B-24