Filter
Top Products
B – Command Reference
Commands
SN0054628-00 A B-11
Q
See Also "Disable Eth Command" on page B-9
"Modify Eth Command" on page B-13
"Show Eth Command" on page B-21
"Show Eths Command" on page B-22
Enable Port Command
Enables the specified Fibre Channel port number so that it can send and receive
Fibre Channel traffic.
Syntax enable port
[port number]
[*]
Keywords enable port [port number]
An integer 1-8 for SANbox 8200-08 SSP/SANbox 8202-08 SSP or 1-16 for
SANbox 8202-16 SSP to indicate the Fibre Channel port.
enable port [*]
* indicates all Fibre Channel ports.
See Also "Disable Port Command" on page B-9
"Modify Port Command" on page B-14
"Modify Ports Command" on page B-15
"Show Port Command" on page B-23
"Show Ports Command" on page B-24
Enable snmpv3 Command
By default, the system runs Simple Network Management Protocol, version 2.
Enabling SNMPv3 means that SNMPv3 is running instead of SNMPv2.
Syntax enable snmpv3
See Also "Disable snmpv3 Command" on page B-10
"Show snmpv3 Command" on page B-26
Enable User Command
Enables the user account that was previously disabled using the Disable User
Command command.
Syntax enable user [user name]
Keywords enable user [user name]
Name of the user account that you are enabling.