Filter
Top Products
3 – Getting Started with SANbox SSP
Setting Up SANbox SSP
SN0054628-00 A 3-5
Q
To mount SANbox SSP in a rack:
NOTE:
■ See manufacturer’s instructions included with the slide mount kit, the rack
mount kit, and the brackets.
■ Shelf mounting is independent of rack depth.
There are two types of rack mount kits available: the slide kit accommodates rack
depths from 20 inches to 30 inches. The direct rack mount kit requires a rack depth
of 21.5 inches.
NOTE: Air flows from the fan side to the port side in the SANbox SSP. When
installing SANbox SSP in a rack, orient the unit so that the port side faces
the rack's air exit.
You can see the Small Form-Factor Pluggable transceivers and power
and Ethernet cables from the port side.
To install the power supplies:
1. Remove the power supply from the packaging container.
2. Insert the power supply into the designated slot on the far left, which is located
above the fan assembly as shown in the following diagram, so that the power
supply is flush with the fan assembly and the label is facing up.
You may need to apply force when inserting the power supply to make sure it
is installed all the way into the slot.
Figure 3-3. Inserting the Left Power Supply