Filter
Top Products
B – Command Reference
Commands
SN0054628-00 A B-9
Q
See Also "Create User Command" on page B-8
"Disable User Command" on page B-10
"Enable User Command" on page B-11
"Show User Command" on page B-27
"Show Users Command" on page B-27
Disable Eth Command
SANbox SSP includes three Ethernet connections, MGMT, HA1, and HA2. This
command disables the specified Ethernet connection so that it cannot send or
receive network traffic.
This command is used for tightened security purposes. Once you disable the
Ethernet connections using this command, you can access the CLI and administer
SANbox SSP only from the serial console.
Syntax disable eth [ethernet name]
Keywords disable eth [ethernet name]
Name of the Ethernet that you are disabling: MGMT, HA1, or HA2.
Notes If you are connected through the management port, disabling the MGMT Ethernet
terminates any active network GUI and CLI sessions, requiring relogin. If you are
using the CLI on the serial console, the connection is not be disrupted.
See Also "Enable Eth Command" on page B-10
"Modify Eth Command" on page B-13
"Show Eth Command" on page B-21
"Show Eths Command" on page B-22
Disable Port Command
Disables the specified Fibre Channel port number so that it cannot send and
receive Fibre Channel traffic.
Syntax disable port
[port number]
[*]
Keywords disable port [port number]
Port number is an integer 1-8 for SANbox 8200-08 SSP/SANbox 8202-08 SSP or
1-16 for SANbox 8202-16 SSP to indicate the Fibre Channel port.
disable port [*]
* indicates all Fibre Channel ports.