Filter
Top Products
7 Windows/Dialogs
7.7 H/W Break Point Setting Window
The H/W Breakpoint Setting window is used to set hardware breakpoints for the Emulators.
• The events listed below can be specified as break events. If the contents of events are altered,
they are marked by an asterisk (*) on the title bar. The asterisks (*) are not displayed after
setting up the emulator.
- The debugger for M32C
Memory Access, Bit Access, External Trigger
(* Can be substituted by memory access. (Access type = Read))
- The debugger for M16C/R8C
Fetch, Memory Access, Bit Access, Interrupt, External Trigger
- The debugger for 740
Fetch, Memory Access, Bit Access, Interrupt, External Trigger
• Events at up to six points can be used.
• These events can be combined in one of the following ways:
- Break when all of the valid events are established (AND condition)
- Break when all of the valid events are established at the same time (simultaneous AND
condition)
- Break when one of the valid events is established (OR condition)
- Break upon entering a break state during state transition (State Transition condition)
• At the time the debugger starts up, the hardware breaks have no effect.
101