Renesas M16C PC4701 Network Card User Manual


 
7.8 Protect Window
The Protect window sets the protect break (memory protect) function of the emulator.
The protect break function is disabled at start of the debugger.
Three types of protect break attributes are provided as below:
- Access Disable (read/write disabled, display in red)
- Read Only (write disabled, display in yellow)
- R/W Enable (read/write enabled, display in sky blue)
The protect break area is a 256 KB continuous area starting from the 64 KB boundary.
You can use the following two methods to set protect break.
- Specify from the target program session information.
- Specify the memory attribute of the desired address range.
7.8.1 Extended Menus
This window has the following popup menus that can be brought up by right-clicking in the window.
Menu
Function
Section Set protect break attribute by the section information.
Base Address...* Change protect base address.
Attribute... Set protect break attribute.
Mode Switch enable or disable protect break function.
Toolbar display Display toolbar.
Customize toolbar... Open toolbar customize dialog box.
Allow Docking Allow window docking.
Hide Hide window.
*:The debugger for 740 doesn't support, because the entire memory area is protection area.
146