5.1.1 MCU Tab
The specified content becomes effective when the next being start.
5.1.1.1 Specifying the MCU file
Click the "Refer" button.
The File Selection dialog is opened. Specify the corresponding MCU file.
• An MCU file contains the information specific to the target MCU.
• The specified MCU file is displayed in the MCU area of the MCU tab.
If the corresponding MCU file is not contained in the debugger/emulation pod, you must create a new
MCU file. To do this, see the following:
"
5.6 Method of making MCU file "
5.1.1.2 Setting of the Communication Interface
The displayed data varies depending on the specified communication interface.
The available communication interface varies depending on the products.
The following shows the setting for each communication interface.
• Refer to "
5.2.1Setting of the USB Interface"
• Refer to "
5.2.2Setting of the LPT Interface"
• Refer to "
5.2.3Setting of the LAN Interface"
• Refer to "
5.2.4Setting of the Parallel Interface"
• Refer to "
5.2.5Setting of the Serial Interface"
34