Filter
Top Products
7.11.4 Configuration of Source Mode
When only source mode is selected, trace information is displayed in source mode. Source mode is
configured as shown below.
1. Line number display area: Shows the line number information of the displayed file. Double-click
here to bring up a dialog box to change the displayed file.
2. Address display area: Shows addresses corresponding to source lines. Double-click here to bring
up a dialog box to search for addresses.
3. Referenced cycle display area: Shows the currently referenced cycle that is marked by ">>."
Furthermore, the addresses corresponding to source lines, if any, are marked by "-."
4. Source display area: Shows the content of the source file.
5. File name: Shows the file name of the currently displayed source file.
6. Referenced cycle: Shows the currently referenced cycle.
7. Referenced address: Shows the address corresponding to the currently referenced cycle.
8. Referenced time: Shows the time information corresponding to the currently referenced cycle.
Other display areas are the same as in bus mode.
174