Renesas M16C PC4701 Network Card User Manual


 
12 Attention
269
12.2.5 Hardware Event
The debugger does not support a command fetch (Fetch) or an interrupt as a hardware event.
If you specify word-length (2-byte length) data from an odd address as an event in the following
data accesses, the event is not detected. Also, even when any other bit of the address that
contains a specified bit is accessed during bit access, the event may become effective.
- Hardware Break Event
- Real-time Trace Event
- Time Measurement Event
In the PID setting, you can specify the access size (BYTE/WORD). However, if you specify an odd
address in the "Address:" field, you cannot specify the WORD size.
Examples to specify the event for data access with its value comparison.
Address Access size 16bit data bus 8bit data bus
Even Address WORD
ex.: mov.w #1234h, 8000h
Address: 8000h
Data: 1234h
Data Mask: Don't care
<-
Even Address BYTE
ex.: mov.b #34h, 8000h
Address: 8000h
Data: 34h
Data Mask: 00FFh
<-
Odd Address WORD
ex.: mov.w #1234h, 8001h
Not supported <-
Odd Address BYTE
ex.: mov.b #34h, 8001h
Address: 8001h
Data: 3400h
Data Mask: FF00h
Address: 8001h
Data: 34h
Data Mask: 00FFh
12.2.6 Time Measurement Resource
You need to specify the operating frequency of mcu for debugger to calculate the time for Trace
window, Time measurement window, or other functions.
You can set it in MCU tab of INIT dialog box. If you use the mcu at 10MHz div 8, please enter 10 and
8 to edit boxes.
12.2.7 CPU rewrite
You can not debug the program using CPU rewrite.
12.2.8 MR STK script command
The MR STK BASE command automatically sets the area where the stack consumption can be
measured. The area set by this command is range of 256KB including the start address of the
system stack. If you want to set other area, please use not the MR STK BASE script command
but the CoVerage BASE script command.