Filter
Top Products
84
TROUBLESHOOTING
Error Messages (
1
/
3
)
The table below explains the error messages that may appear on the display and the appropriate
action to take.
Message
“Close cover”
“Add paper”
“Toner near end”
“Add Toner”
“Clear paper”
“Memory overflow”
“Remove original”
(when original is set
in ADF)
“Memory full” and
“Press Stop”
Cause
Front unit is open.
Machine is out of paper.
Machine is almost out of
toner.
Toner cassette is not loaded
correctly.
Machine is out of toner.
Paper misfeed or paper
will not feed at all.
Not enough memory
capacity. (PC printing
only)
Original misfeed or paper
will not feed at all.
Too much sort copy data.
Too many sort copy pages.
Remedy
Close the front unit.
If a copy job is in progress, set
the copy quantity again.
Load paper.
If a copy job is in progress, set
the copy quantity again.
Prepare a toner cassette for re-
placement.
Correctly load the toner cassette
into the machine.
If a copy job is in progress, set
the copy quantity again.
Replace the toner cassette.
Remove the misfed paper. If a
copy job is in progress, set the
copy quantity again.
If paper persistently misfeeds, carry
out the procedure on page 89.
Either lower the printer driver
Resolution setting, or increase
memory capacity by installing a
larger SIMM. Press any opera-
tion panel key to clear the error
message from the display.
Remove the original from the
ADF. If a copy job is in progress,
set the copy quantity again.
Press to cancel sort copying.
If you need to print big copy jobs,
increase the memory capacity.
Press to print pages al-
ready stored in memory. To can-
cel the job, press . If you
need to print big copy jobs, in-
crease the memory capacity.
Page
P. 3
P.11,19
—
P. 2
P.88
P.88
P.23
P.69
P.23, 78
P.23, 78