Filter
Top Products
42
TROUBLESHOOTING
Message
Close cover
Add paper
Toner near end
Add Toner
Clear paper
Memory overflow
Remove original (when
original is set in ADF)
“Remove original”
and “from glass”
“Memory full” and
“Press Stop”
“Memory full” and
“Press Start”
Error 90
Error XX
Cause
Top unit is open.
Machine is out of paper.
Machine is almost out of
toner.
Toner cassette is not loaded
correctly.
Machine is out of toner.
Paper misfeed.
Not enough memory ca-
pacity.
Original misfeed.
An original is under the
platen cover.
Too much sort copy data.
Too many sort copy pages.
Locked scanner.
Possible machine defect.
Page
p.3
p.10,18
—
p.2
p.50
p.43
p.21,25
p.47
—
p.21,37
p.21, 37
p.3
p.8
Error Messages
If you have a problem with the machine and you can not resolve it by referring to the
information in this chapter, contact your service representative.
In case of “Error XX” messages, be sure to turn off the machine before calling.
Remedy
Close the top unit.
Load paper, and set the copy
quantity again during a copy job.
Prepare a toner cassette for re-
placement.
Correctly load the toner cassette
into the machine.
Replace the toner cassette, and
set the copy quantity again dur-
ing a copy job.
Remove the misfed paper, and
set the copy quantity again dur-
ing a copy job.
Either lower the printer driver's
"Resolution" setting or increase
memory capacity by installing a
larger SIMM. Press any opera-
tion panel key to clear the error
message from the display.
Remove the original from the ADF,
and set the copy quantity again.
Remove the original. If there is
no original, open the platen
cover and close it again.
Press
to cancel sort copy,
and perform the copy operation
without sorting. If you need to
print big sort copy jobs, increase
memory capacity.
Press to print pages already
stored in memory. If you need
to print big sort copy jobs, in-
crease memory capacity.
Unlock the scanner lock, turn the
machine off and then back on.
Turn power off and then back
on again.