Filter
Top Products
ii
• Use of controls or adjustment or performance of procedures other than those
specified in this manual may result in hazardous radiation exposure.
• Only connect the machine to the power source described on the inside of the
front cover.
• Avoid multi-wiring.
• Do not damage, break or make any modifications to the power cord. Do not
place heavy objects on it, pull it hard or bend it more than necessary. These
actions could cause an electric shock or fire.
• Do not plug or unplug the power cord with your hands wet. Otherwise, an
electric shock might occur.
• Make sure the wall outlet is near the machine and freely accessible so that in
event of an emergency it can be unplugged easily.
• Do not remove any covers or screws other than those specified in this manual.
Some parts of the machine are at a high voltage and could give you an elec-
tric shock. Also, reflected eye contact with the leaser beam may cause seri-
ous eye damage. When the machine needs to be checked, adjusted, or re-
paired, contact your service representative.
• Do not take apart or attempt any modifications to this machine. There is a
risk of fire, electric shock, explosion or loss of sight.
• If the machine looks damaged or breaks down, smoke is coming out, there
is a strange smell or anything looks unusual, immediately turn off the power
switch then unplug the power cord from the wall. Do not continue using the
machine in this condition. Contact your service representative.
• If metal, liquid or foreign matter falls into the machine, turn off the power
switch, and unplug the power cord.
Contact your service representative. Do not keep using the machine with a
fault or defect.
• Do not put any metal objects or containers holding water (e.g. vases, flower-
pots, glasses) on the machine. If the contents fall inside the machine, a fire
or electric shock could occur.
• Do not incinerate used toner or toner cassettes. Toner dust might ignite when
exposed to an open flame. Dispose of the used toner cassettes according to
local regulations for plastics.
WARNING: