Filter
Top Products
42
TROUBLESHOOTING
Message
“Close cover”
“Add paper”
“Toner near end”
“Add Toner”
“Clear paper”
“Memory overflow”
“Remove original”
(when original is set in
ADF)
“Original left” and
“on glass”
“Memoly full” and
“Press Stop”
Cause
Top unit is open.
Machine is out of paper.
Machine is almost out of
toner.
Toner cassette is not loaded
correctly.
Machine is out of toner.
Paper misfeed, or paper
will not feed at all.
Not enough memory ca-
pacity (PC printing only).
Original misfeed, or paper
will not feed at all.
An original may be under
the platen cover.
Too much sort copy data.
Page
p.3
p.10,18
—
p.2
p.52
p.44,49
p.21,25
p.48
—
p.21,37
Error Messages (
1
/2)
The table below explains the error messages that may appear on the display and the appropriate
action to take.
Remedy
Close the top unit. If a copy job
is in progress, set the copy quan-
tity again.
Load paper. If a copy job is in
progress, set the copy quantity
again.
Prepare a toner cassette for re-
placement.
Correctly load the toner cassette
into the machine.
Replace the toner cassette, and
set the copy quantity again dur-
ing a copy job.
Remove the misfed paper. If a
copy job is in progress, set the
copy quantity again.
If paper persistently msifeeds,
carry out the procedure on page
49.
Either lower the printer driver's
"Resolution" setting or increase
memory capacity by installing a
larger SIMM. Press any opera-
tion panel key to clear the error
message from the display.
Remove the original from the ADF,
and set the copy quantity again.
Remove the original. If there is
no original, open the platen
cover and close it again.
Press to cancel sort copy,
and perform the copy operation
without sorting. If you need to
print big sort copy jobs, increase
memory capacity.