SMC Networks SMC8708L2 Switch User Manual


 
P
ORT
C
ONFIGURATION
3-125
Configuring Interface Connections
You can use the Port Configuration or Trunk Configuration page to
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed and duplex mode.
Note: Interface settings for the management port can only be configured
from the CLI.
Command Attributes
Port – Port number. (Range: 1-8)
Name – Allows you to label an interface. (Range: 1-64 characters)
Admin – Allows you to manually disable an interface. You can disable
an interface due to abnormal behavior (e.g., excessive collisions), and
then reenable it after the problem has been resolved. You may also
disable an interface for security reasons.
Speed/Duplex
10
– Allows you to manually set the port speed and
duplex mode; i.e., with auto-negotiation disabled. (This is fixed at 10G,
full duplex for Ports 1 - 8.)
Autonegotiation
10
(Port Capabilities) – Allows auto-negotiation to be
enabled/disabled. When auto-negotiation is enabled, you need to
specify the capabilities to be advertised. When auto-negotiation is
disabled, you can force the settings for speed and mode.The following
capabilities are supported.
- 10half - Supports 10 Mbps half-duplex operation
- 10full - Supports 10 Mbps full-duplex operation
- 100half - Supports 100 Mbps half-duplex operation
- 100full - Supports 100 Mbps full-duplex operation
-
10Gfull
- Supports 10 Gbps full-duplex operation
(Default: Disabled for Ports 1-8, enabled for Port 9; Advertised
capabilities for Ports 1-8: 10Gfull, Port 9: 100BASE-TX – 10half,
10full, 100half, 100full)
10. The settings for this parameter cannot be changed.