Filter
Top Products
P
ORT
C
ONFIGURATION
3-131
Web – Click Port, LACP, Configuration. Select any of the switch ports
from the scroll-down port list and click Add. After you have completed
adding ports to the member list, click Apply.
Figure 3-54 LACP Trunk Configuration
CLI – The following example enables LACP for ports 1 to 6. Just connect
these ports to LACP-enabled trunk ports on another switch to form a
trunk.
Console(config)#interface ethernet 1/1 4-170
Console(config-if)#lacp 4-170
Console(config-if)#exit
.
.
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1 4-177
Information of Trunk 1
Basic information:
Port type: 10G
Mac address: 00-30-F1-D4-73-A2
Configuration:
Name:
Port admin: Up
Speed-duplex: 10G full
Capabilities:
Port security: Disabled
Max MAC count: 0
Current status:
Created by: LACP
Link status: Up
Port operation status: Up
Operation speed-duplex: 10G full
Flow control type: None
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4,
Console#