SMC Networks SMC8708L2 Switch User Manual


 
C
OMMAND
L
INE
I
NTERFACE
4-88
Due to the size limit of the flash memory, the switch supports only two
operation code files.
The maximum number of user-defined configuration files depends on
available memory.
You can use “Factory_Default_Config.cfg” as the source to copy from
the factory default configuration file, but you cannot use it as the
destination.
To replace the startup configuration, you must use startup-config as
the destination.
The Boot ROM and Loader cannot be uploaded or downloaded from
the TFTP server. You must follow the instructions in the release notes
for new firmware, or contact your distributor for help.
For information on specifying an https-certificate, see “Replacing the
Default Secure-site Certificate” on page 3-83. For information on
configuring the switch to
use HTTPS for a secure connection, see “ip
http secure-server” on page 4-43.
Example
The following example shows how to upload the configuration settings to
a file on the TFTP server:
The following example shows how to copy the running configuration to a
startup file.
Console#copy file tftp
Choose file type:
1. config: 2. opcode: <1-2>: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#
Console#copy running-config file
destination file name: startup
Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#