Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-278
Example
The following shows that port 11 in VLAN 1 is attached to a multicast
router:
IP Interface Commands
An IP addresses may be used for management access to the switch over
your network. The IP address for this switch is obtained via DHCP by
default. You can manually configure a specific IP address, or direct the
device to obtain an address from a BOOTP or DHCP server when it is
powered on. You may also need to a establish a default gateway between
this device and management stations or other devices that exist on another
network segment.
Basic IP Configuration
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
Console#
Table 4-72 Basic IP Configuration Commands
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-279
ip default-gateway Defines the default gateway through which an
in-band management station can reach this
device
GC 4-280
ip dhcp restart Submits a BOOTP or DCHP client request PE 4-281
show ip interface Displays the IP settings for this device PE 4-282
show ip redirects Displays the default gateway configured for
this device
PE 4-282
ping Sends ICMP echo request packets to another
node on the network
NE,
PE
4-283