SMC Networks SMC8708L2 Switch User Manual


 
C
OMMAND
L
INE
I
NTERFACE
4-120
access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
standard – Specifies an ACL that filters packets based on the source
IP address.
extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
show access-list
ip
mask-precedence
Shows the ingress or egress rule masks for
IP ACLs
PE 4-131
ip access-group Adds a port to an IP ACL IC 4-132
show ip
access-group
Shows port assignments for IP ACLs PE 4-132
map access-list ip Sets the CoS value and corresponding
output queue for packets matching an
ACL rule
IC 4-133
show map
access-list ip
Shows CoS value mapped to an access list
for an interface
PE 4-134
match access-list
ip
Changes the 802.1p priority, IP
Precedence, or DSCP Priority of a frame
matching the defined rule (i.e., also called
packet marking)
IC 4-135
show marking Displays the current configuration for
packet marking
PE 4-136
Table 4-34 IP ACL Commands (Continued)
Command Function Mode Page