Filter
Top Products
I
NTERFACE
C
OMMANDS
4-169
Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Table 4-44 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters
interface configuration mode
GC 4-170
description Adds a description to an interface
configuration
IC 4-170
speed-duplex
*
* This command is not supported.
Configures the speed and duplex operation of
a given interface when autonegotiation is
disabled
IC 4-171
negotiation
*
Enables autonegotiation of a given interface IC 4-172
capabilities
*
Advertises the capabilities of a given interface
for use in autonegotiation
IC 4-173
shutdown Disables an interface IC 4-174
switchport
broadcast
packet-rate
Configures the broadcast storm control
threshold
IC 4-175
clear counters Clears statistics on an interface PE 4-176
show interfaces
status
Displays status for the specified interface NE,
PE
4-177
show interfaces
counters
Displays statistics for the specified interfaces NE,
PE
4-178
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE,
PE
4-180