SMC Networks SMC8708L2 Switch User Manual


 
C
OMMAND
L
INE
I
NTERFACE
4-256
Example
This example shows how to assign WRR weights to each of the priority
queues:
Related Commands
show queue bandwidth (4-258)
queue cos-map
This command assigns class of service (CoS) values to the priority queues
(i.e., hardware output queues 0 - 7). Use the no form set the CoS map to
the default values.
Syntax
queue cos-map queue_id [cos1 ... cosn]
no queue cos-map
queue_id - The ID of the priority queue.
Ranges are 0 to 7, where 7 is the highest priority queue.
cos1 ... cosn - The CoS values that are mapped to the queue ID. It is a
space-separated list of numbers. The CoS value is a number from 0
to 7, where 7 is the highest priority.
Default Setting
This switch supports Class of Service by using eight priority queues,
with Weighted Round Robin queuing for each port. Eight separate
traffic classes are defined in IEEE 802.1p. The default priority levels
are assigned according to recommendations in the IEEE 802.1p
standard as shown below.
Console#configure
Console(config)#interface ethernet 1/5
Console(config-if)#queue bandwidth 1 3 5 7 9 11 13 15
Console(config-if)#
Table 4-64 Default CoS Priority Levels
Queue
01234567
Priority
20134567