Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-284
Example
DNS Commands
These commands are used to configure Domain Naming System (DNS)
services. You can manually configure entries in the DNS domain name to
IP address mapping table, configure default domain names, or specify one
or more name servers to use for domain name to address translation.
Note that domain name services will not be enabled until at least one name
server is specified with the
ip name-server command and domain lookup
is enabled with the ip domain-lookup command
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5
seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#
Table 4-73 DNS Commands
Command Function Mode Page
ip host Creates a static host name-to-address mapping GC 4-285
clear host Deletes entries from the host name-to-address
table
PE 4-286
ip domain-name Defines a default domain name for incomplete
host names
GC 4-287
ip domain-list Defines a list of default domain names for
incomplete host names
GC 4-288
ip name-server Specifies the address of one or more name
servers to use for host name-to-address
translation
GC 4-289