Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-280
Note: Only one VLAN interface can be assigned an IP address (the
default is VLAN
1). This defines the management VLAN, the only
VLAN through which you can gain management access to the
switch. If you assign an IP address to any other VLAN, the new IP
address overrides the original IP address and this becomes the new
management VLAN.
Example
In the following example, the device is assigned an address in VLAN 1.
Related Commands
ip dhcp restart (4-281)
ip default-gateway
This command establishes a static route between this switch and devices
that exist on another network segment. Use the no form to remove the
static route.
Syntax
[no] ip default-gateway gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Command Usage
A gateway must be defined if the management station is located in a
different IP segment.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#