Filter
Top Products
221Macros
Chapter 1 MVS-8000 Functions
Notes
• After setting a macro attachment to a cross-point button in the auxiliary bus
control block, if in the Setup menu you change the assignment of buses to the
AUX delegation buttons, the macro attachment setting disappears.
• After setting a macro attachment to a button for which you can perform
function replacement or function assignment, if you change the function
assignment to the button, the macro attachment setting disappears.
• After setting a macro attachment to a cross-point button in the cross-point
control block, if you change the function assignment to the button, the macro
attachment setting disappears.
Enabling and disabling macro attachment
You can temporarily disable the macro attachment settings. When a macro
attachment is disabled, pressing the button does not cause execution of the
assigned macro.
You can enable and disable macro attachments for the PGM/PST bank and M/
E banks individually.
Setting a macro attachment to a fader lever
You can set a macro attachment to any particular position of a fader lever in the
transition control block.
Notes
• In macro-only mode it is not possible to set a macro attachment.
• It is not possible to set a macro attachment to a fader lever in the keyframe
control block or downstream key control block.
• For a split fader, you can set a macro attachment to the main split fader.
For details of a split fader, see “Split Fader” (page 373).
Clearing the macro attachments
You can clear all of the macro attachments in a single operation.
Displaying the macro attachment list
You can display the macro attachment settings in the form of a list in the menu
display to check them.