Filter
Top Products
272
Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
control block. In this state, the [M/E 1]
to [M/E 3] buttons, [P/P] button and
[DME1] to [DME8] buttons function
as the device 1 to device 12 allocation
buttons as follows.
[M/E1] (DEV1): device 1
[M/E2] (DEV2): device 2
[M/E3] (DEV3): device 3
[P/P] (DEV4): device 4
[USER] (FM1CLIP): frame memory
clip 1
[Unused] (FM2CLIP): frame memory
clip 2
[DME1] (DEV5): device 5
[DME2] (DEV6): device 6
[DME3] (DEV7): device 7
[DME4] (DEV8): device 8
[Unused] (FM LOOP): frame memory
loop
[DME5] (DEV9): device 9
[DME6] (DEV10): device 10
[DME7] (DEV11): device 11
[DME8] (DEV12): device 12
To exit from this mode, press the
[DEV] button again, turning it off.
When the [RUN CTRL] button is
selected: This enables the effect run
control mode in the device control
block.
When the [RSZR CTRL] button is
selected: This enables the resizer
control mode in the device control
block of the MVS-8000G.
For details on resizer, see page 419.
The functions of the operation buttons,
trackball, and Z-ring vary with the
operation mode as follows.
b Operation buttons
When the positioner operation mode is
enabled
K1 CB1: Press this button to enable wipe
pattern position setting for key 1
(DSK1).
When the [USER] button is selected,
pattern position setting for color
background 1 is enabled.
K2 CB2: Press this button to enable wipe
pattern position setting for key 2
(DSK2).
K3: Press this button to enable wipe pattern
position setting for key 3 (DSK3).
K4: Press this button to enable wipe pattern
position setting for key 4 (DSK4).
MAIN: Press this button to enable main
wipe pattern position setting for normal
transitions.
SUB: Press this button to enable sub wipe
pattern position setting for normal
transitions.
Among the [K1 CB1] button, [K2 CB2]
button, [K3] button, [K4] button, [MAIN]
button, and [SUB] button, you can select
multiple buttons.
POS: Press this button to enable pattern
movement in the x-axis and y-axis
directions with the trackball.
When the [USER] button is selected,
this enables the trackball to move the
pattern in the x-axis and y-axis
directions, and the Z-ring to adjust the
size of the pattern.
X, Y: These restrict the axes affected by the
trackball and Z-ring to the x- or y-axis.
Z: This restricts the axes affected by the
trackball and Z-ring to the z-axis.
CTR (center): When this button is pressed,
the pattern position returns to the
center. When the [USER] button is
selected, the pattern size also returns to
50.00.
SHIFT/CLR WORK BUFR: Press this
button twice in rapid succession to
reset all parameters on the target M/E
or PGM/PST to their initial values.