Filter
Top Products
230
Multi Program 2
Chapter 1 MVS-8000 Functions
Multi Program 2
Overview
What is Multi Program 2?
By operating the switcher in Multi Program 2 mode, a single switcher mix/
effects bank can be used to create two separate video outputs, referred to as
“main” and “sub.” You can set backgrounds, keys, and transitions for each of
main and sub. Keys 2 to 4, however, are common to main and sub.
For example, immediately after a score in baseball two versions of the scene
can be provided as shown below, and switched simultaneously.
Note
The Multi Program 2 function is only supported on the MVS-8000A/8000G.
To enable this function requires the BZS-8200 Multi Program 2 software.
Depending on the CPU module, this function may not be supported. For
details, consult your Sony service representative or sales representative.
Using the software
To use the Multi Program 2 software, you are required to enter an install key
which validates the software. (If the software has been factory installed, the
install key is not required.)
TEAM A
TEAM B
Background A
Key 1
Program output for “Main”
Background B
Background A
(signal from utility 2 bus)
Key 3
Background B
(signal from utility 3 bus)
Program output for “Sub”