Filter
Top Products
359Executing a Transition
Chapter 3 Transitions
Executing an Auto Transition
Transition control block (standard type)
To execute a transition on the M/E or PGM/PST bank by a button operation,
use the following procedure in the transition control block.
For an overview of the auto transition, see page 45.
To carry out an instantaneous cut transition: Press the [CUT] button.
To carry out a gradual transition: Press the [AUTO TRANS] button.
This executes the transition at the preset transition rate (see page 352).
While the transition is executing, the [AUTO TRANS] button lights
amber. When it completes the button goes off.
To complete a partially executed transition instantaneously: Press the
[CUT] button.
The [AUTO TRANS] button goes off.
Executing a Transition With the Fader Lever (Manual
Transition)
To execute a manual transition with the transition control block fader lever, use
the following procedure.
For an overview of the manual transition, see page 45.
BKBD KEY1 KEY2 KEY3 KEY4
KEY
PRIOR
MIX
ALL
PST
COLOR
MIX
NAM
WIPE
SUPER
MIX
DME
PRIOR
SET
NORM
NORM
/REV
REV
TRANS
PVW
PTN
LIMIT
LIMIT
SET
KF
AUTO
TRANS
CUT
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
Fader lever
AUTO TRANS button
CUT button