Filter
Top Products
308
Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
Downstream Key/Fade-to-Black Control Block
a Key delegation buttons
Press DSK1 or DSK2, to select the keyer.
Each button can be assigned to any key in
setup (see Chapter 16 “Overall Control
Panel Settings (Config Menu)” (Volume
2)).
While these buttons are held down, you can
select a key source with the cross-point
buttons on the key bus.
Pressing one of these buttons twice in rapid
succession changes its state so that you can
make cross-point selections on the
corresponding key bus in the PGM/PST
bank.
a) The key bus selection button [KEY3] in the P/P
cross-point control block goes off.
b) The key bus selection button [KEY4] in the P/P
cross-point control block goes off.
b Independent key transition
execution section
DSK1 ON, DSK2 ON buttons: Press these
to cut in the corresponding downstream
key 1 or 2. When the key is already
inserted, pressing the button cuts it out.
Each button lights red when the
corresponding key is inserted in the
program output (final output from the
AUTO PST P/P
FTB
DME
K
DME
V
M/E
3
M/E
2
M/E
1
M/E
3K
M/E
2K
M/E
IK
P/P
K
DSK1 K-SSDSK2
DSK2
ON
DSK1
ON
AUTO
TRANS
AUTO
TRANS
1 Key delegation
buttons
2 Independent key
transition
execution section
3 K-SS button
4 Key source name display/key snapshot buttons
5 FTB button
6 AUTO button
7 Preview selection buttons
Key delegation button
(double press)
Corresponding
key bus
[DSK1]
key 1
a)
[DSK2]
key 2
b)
Key delegation button
(double press)
Corresponding
key bus