Filter
Top Products
289Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
• AUX buses 1 to 48
• MONITOR 1 to MONITOR 8 buses
• FMS 1 (frame memory source 1) and
FMS 2 buses
• DME 1V to DME 8V buses
• DME 1K to DME 8K buses
• EDIT PVW (preview) bus
• M/E-1 UTILITY 1 and M/E-1 UTILITY
2 buses
• M/E-2 UTILITY 1 and M/E-2 UTILITY
2 buses
• M/E-3 UTILITY 1 and M/E-3 UTILITY
2 buses
• P/P UTILITY 1 and P/P UTILITY 2
buses
• DSK 1 fill to DSK 4 fill buses
• DSK 1 source to DSK 4 source buses
• M/E-1 Key 1 fill to Key 4 fill buses
• M/E-2 Key 1 fill to Key 4 fill buses
• M/E-3 key 1 fill to M/E-3 key 4 fill buses
• M/E-1 Key 1 source to Key 4 source
buses
• M/E-2 Key 1 source to Key 4 source
buses
• M/E-3 key 1 source to M/E-3 key 4
source buses
• M/E-1 external DME bus
• M/E-2 external DME bus
• M/E-3 external DME bus
• P/P external DME bus
• DME UTILITY1 and DME UTILITY2
buses
• CCR (color corrector) 1 and 2 buses
b Selected source name displays
These show the name of the currently
selected signal (source) on the bus
corresponding to the delegation button.
c DEST (destination) button
Press this button, turning it on, to display
the names of buses allocated to the
delegation buttons in the selection source
name displays.
In the case of a module without selected
source name displays, this button is invalid.
d Selected bus display
This shows the name of the bus selected by
the auxiliary bus delegation buttons.
e Cross-point buttons
The cross-points in the auxiliary bus control
block are arranged in two rows: an upper
row (1st row) and a lower row (2nd row),
and are allocated to the buses selected with
the AUX delegation buttons. The 1st row
contains the cross-point buttons for
unshifted buses, and the 2nd row contains
the cross-point buttons for shifted buses.
When the DME 1V/K to 8V/K buses are
selected with the AUX delegation buttons,
the 1st row cross-point buttons are for the
currently showing side of DME, and the
2nd row are for the reverse side.
By holding down the [2ND] button and
making an AUX delegation selection, you
can allocate the 2nd row to a different bus
from the 1st row.
In this case, if the 32nd button is set to be a
[SHIFT] button (in a 32-button system), the
cross-point buttons switch to the shifted
allocation while the [SHIFT] button is
enabled.
f XPT HOLD (cross-point hold)
buttons
Press one of these buttons, turning it on, to
enable cross-point hold.
g KEY button
While this button is held down, you can use
the cross-point row of buttons to select key
signals.
h 2ND button
After selecting a bus with an AUX
delegation button, hold down this button,
and select another AUX delegation, thus
allocating a different bus in the 2nd row
from the 1st row.