Filter
Top Products
403Key Setting Operations Using Menus
Chapter 4 Keys
Assigning a DME output signal as a monitor signal
1
In the Processed Key menu, press [Monitor].
The Monitor menu appears.
2
Press [Monitor Set], turning it on.
3
In the <DME Select> group, select the DME channel (DME1 to DME8) to
be used.
This assigns the selected DME output to DME MON V and DME MON K.
The colors with which [DME1] to [DME8] are lit show the key assignment
status.
Lit green: DME currently being monitored
Lit amber: DME that can be monitored
Off: Unassigned DME
Specifying the Key Output Destination
Using the key processed keyer signals (external processed key)
To select the key processed keyer key fill and key source signals on the AUX
buses, press [Ext Proc Key], turning it on, in the Processed Key menu.
This assigns the key fill and key source signals for M/E-1 key 1 to reentry
signals PROC V and PROC K.
Note
You cannot select the PROC V and PROC K signals using the cross-point
selection buttons of the M/E or PGM/PST bank.
Using the key processed keyer signals or signals to which a DME
effect is applied in frame memory (frame memory feed)
To use the key processed keyer key fill and key source signals on the frame
memory source buses, in the Processed Key menu, press [FM Feed]. [Ext Proc
Key] turns on, and the key fill and key source signals processed on the
currently selected keyer are automatically assigned to frame memory source
buses 1 and 2. When a DME is selected on the keyer, the key fill and key source
signals to which a DME effect is applied are assigned.