Filter
Top Products
259Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
of the source name display, for each source
separately. You can set the source name
display mode and background color in a
Setup menu.
f SHIFT button
When this button is enabled, either the
source name displays show the shifted
signal names, or the shifted signals for all
buses in this M/E (P/P) bank are enabled.
You can select either mode in a Setup
menu.
Each press of the button toggles between
the enabled and disabled states.
In the case of a module without source
name displays, when “Display” is selected
in the Setup menu, this button is invalid.
g M/E bank display
This indicates the notional mix/effect bank
name to which the particular M/E or PGM/
PST bank is assigned, as a four-character
identifier.
h Macro buttons
PRE MCRO (pre macro) button: Use this
button to set a macro attachment in pre
macro mode. For setting in macro only
mode, use this in combination with a
macro only set button assigned to the
utility/shotbox control block or a user
preference button. Alternatively,
without using the button, you can make
the selection simply, by pressing
simultaneously with the [POST
MCRO] button.
When dual background bus mode is
selected in setup, this switches the dual
background bus mode on and off.
When set to utility/shotbox mode, this
enables and disables the use of the key
2 row as a utility/shotbox.
If in setup this is assigned to the
function for disabling cross-point
button operations, then it enables or
disables cross-point button operations.
POST MCRO (post macro) button: Use
this button to set a macro attachment in
post macro mode. For setting in macro
only mode, use this in combination
with a macro only set button assigned
to the utility/shotbox control block or a
user preference button. Alternatively,
without using the button, you can make
the selection simply, by pressing
simultaneously with the [PRE MCRO]
button.
When dual background bus mode or
utility/shotbox mode is selected in
setup, this button is disabled.
If in setup the function for disabling
cross-point button operations is
assigned to the [PRE MCRO] button,
then this button is disabled.
MCRO ATTCH ENBL (macro
attachment enable) button: When
this button is on, the macro attachments
set for the buttons of the M/E bank are
enabled.